Fiber optic inspection microscopes are essential tools used for inspecting and analyzing the ends of fiber optic cables. they are commonly used to ensure the quality and performance of the cables before and after installation. however, using a fiber optic inspection microscope requires some level of expertise to get accurate results. in this article, we will be discussing how to properly use a 400x fiber optic inspection microscope for accurate results.
Step 1: getting started
Before you begin inspecting your fiber optic cable, ensure that your microscope is properly set up. you will need to adjust the focus ring and the light intensity to obtain a clear image of the fiber end face. adjust the magnification to 400x for optimal performance.
Step 2: cleaning the fiber end face
The fiber end face must be clean and free from debris to obtain accurate results. use a lint-free cleaning cloth and a small amount of isopropyl alcohol to clean the end face. be sure to clean the entire surface of the end face.
Step 3: inspect the fiber end face
Place the end face of the fiber optic cable onto the microscope’s stage and align it with the objective lens. adjust the focus to get a clear and sharp image of the end face. inspect the entire surface of the end face, looking for any defects or contaminants such as cracks, chips, scratches, and dirt.
Step 4: interpret the results
Once you have inspected the fiber end face, interpret the results. if you notice any defects or contaminants, clean the end face using the same process and re-inspect. repeat the process until you obtain a clean and clear image.
In conclusion, using a fiber optic inspection microscope requires proper usage for accurate results. by following these simple steps, you can achieve accurate results in your inspections. remember to always clean the end face of the fiber optic cable before inspecting and interpret the results to ensure the quality and performance of your fiber optic cable.